FIND MY Location
Find Your Location

THE QUICK, SIMPLE INJECTION
FOAM INSTALLATION PROCESS

Our insulation installation process is quick and simple.

Most insulation materials—including cellulose, EPS boards, and fiberglass batting—only work for certain building materials. At USA Insulation, our proprietary injection foam works for almost every type of home building material. Not only is USA Premium Foam® Insulation one of the best and most effective insulation products on the market, it is also one of the most versatile and can typically be installed in less than a day, without tearing apart your home. We can insulate just about any type of building, including:

  • Brick
  • Shingle / Shake
  • Block
  • Vinyl Siding
  • Aluminum Siding
  • Stucco
  • Basement Walls

Our Step-by-Step Process

Step 1

Make Foam On-Site

Before we begin installing our premium injection foam, we mix it right on-site to ensure a high-quality insulation.

Step 2

Remove Siding (if applicable)

For homes with side paneling, we remove them on each section of wall.

Step 3

Drill Holes

Next, we drill small holes between each wall stud along the side of the home. For homes with brick, we’ll drill holes in the mortar to access the wall.

Step 4

Inject Foam

After drilling holes, we then insert a tube through the holes into the wall cavity and begin to pump in our USA Premium Foam Insulation.

Step 5

Fill Wall Cavities

We thoroughly fill the wall cavity with the injection foam and it squeezes between each gap and crevice, forming an effective barrier. The insulation product hardens within minutes!

Step 6

Plug Holes

After insulating, we plug each hole, or cover with mortar dyed to match yours, and return the siding to the home with no visible difference.