High Contrast Mode:

a house with a front yard

The Quick, Simple Injection Foam
Installation Process

Our insulation installation process is 
quick and simple.

Most insulation materials—including cellulose, EPS boards, and fiberglass batting—only work for certain building materials. At USA Insulation™, our proprietary injection foam works for almost every type of home building material. Not only is USA Premium Foam® Insulation one of the best and most effective insulation products on the market, it is also one of the most versatile and can typically be installed in less than a day, without tearing apart your home. It can even go over existing fiberglass insulation. We can insulate just about any type of building, including:

  • Brick
  • Shingle / Shake
  • Block
  • Vinyl / Aluminum Siding
  • Stucco
  • Hardie Board
Schedule Your Free Inspection
a close-up of some meat
a person holding a clipboard
a man wearing gloves
a man using a drill
a man holding a hose
wall cavity with foam insulation
a man holding a plug
a man and a woman looking at a clipboard

Our
Step-by-Step Process

Pre-Installation Walkthrough

On installation day, we'll start by walking through the interior and around the exterior of your home together, explaining our process and what to expect.

Remove Siding

For homes with side paneling, we remove them on each section of wall. We can also install on brick, shingle/shake, block, vinyl, aluminum, stucco and hardie board exteriors.

Drill Holes

Next, we drill small holes between each wall stud along the side of the home. For homes with brick, we'll drill holes in the mortar to access the wall.

Inject Foam

After drilling holes, we then insert a tube through the holes into the wall cavity and begin to pump in our USA Premium Foam Insulation.

Fill Wall 

We fill the wall cavity with the injection foam and it squeezes between gaps and crevices, forming an effective barrier. The insulation product hardens within minutes!

Plug Holes & Reinstall Siding

After insulating, we plug each hole, or cover with matching mortar, and return the siding to the home with no visible difference. It'll look like we were never there.

Post-Installation Walkthrough

We'll walk back through the interior and around the exterior with you, showing you exactly what we did and ensure that the finished product and clean-up meet your satisfaction.

BBB Accredited
HomeAdvisor Approved
icon
icon
elite service home advisor logo East Valley Phoenix
icon

License # AZ ROC 350080

Find My Local USA Insulation